Task sequence has failed with the error code 0x80070490

Task Sequence has failed with the error code (0x80070490).

task sequence has failed with the error code 0x80070490

How to Fix Error Code 0x80070490 in Windows 10/8/7

with   get

By MadJax , October 3, in Deploy 7. I have this problem with a Lenovo Thinkpad Ts. When trying to reinstall it through SCCM , it gives the task sequence error 0x I searched Google and found that it could be something with a partition. However I have wiped all partitions on the harddrive and I still get it. I tried looking in the logs, but doesn't seem ti find anything.

I managed to figure this out, i was deploying Win 7 and within the TS the image it was deploying was which is the mb System reserved partition, which is why it was failing once i changed this to the deployment was successful Which is strange LOG and F8. I followed your instructions to capture image using capture media in ConfigMgr In the task sequence, i'm selecting image. A little after the fact, but here is my experience of this error code. We had migrated from Domain to another and I could not rebuild the clients into the new domain because of this error.

This file is required and used when the computer restarts the first time from booted after conversion to UEFI is done. They are in the OSDinjection. And that is exactly what is causing the above error at least from what I have seen it could probably be more reasons for it to fail but the two reasons I have seen are the following. The Boot image used are not updated since the upgrade to Configuration Manager In that case the new file is not present in the boot image and the restart will fail.



How to Fix - SCCM task sequence failure - Error Code 0x80070490

However, the particular step this error was being triggered on was when attempting to apply an image. Right off the bat I knew something was wrong as my task sequence would first partition the disk and then apply the image.

Error 0x80070490 when converting BIOS-UEFI in ConfigMgr 1610

But unfortunately, I am getting an error described in the title of this article An error occurred while starting the task sequence 0x If you go and check this website: SCCM error codes , you will have a better overview in what exactly error message means. To find out what had caused this Failed to run task sequence 0x to appear, I have to open a SCCM task log, smsts. What you see is a default place just right after you fire up CMD. But the log is not there. In order to access the log file, type this path:. Also check: Installing PowerShell 3.

The problem was my TS was deploying Image which is the MB boot partition that Windows 7 creates during installation. I pay a quick visit everyday a few blogs and blogs to read articles or reviews, however this website provides quality based content. You are commenting using your WordPress. You are commenting using your Google account. You are commenting using your Twitter account. You are commenting using your Facebook account. Notify me of new comments via email.

.

Failed to run task sequence 0x80070490

.

.

.

.

.

0 thoughts on “Task sequence has failed with the error code 0x80070490

Leave a Reply

Your email address will not be published. Required fields are marked *